- Weng SHOP
- Weng SHOP
Hawke Standard Tolerant Blocks
The Hawke cable blocks have a tolarance that is achieved by having 5 points of contact with the cable that guarantees the sealing of the cable even if it is deformed.
Thanks to this tolerance,
each Hawke block covers a range of diameters between 3 and 4 mm. It is not necessary to mainpulate the block, as this tolerance is archieved by deforming it when the system is compressed.
Hawke Trefoil Insert Blocks
These blocks allow three single phase power cables to be sealed inside of the same cable block. "Available in 90mm and 120mm size"
Hawke Special Insert Blocks
When Hawke Transit System Frames are penetrated by services that are shaped anything other than circular, eg. Busbars, special cables, earthtraps, etc.
Round Transits System
Hawke Round Transit (HRTO)
Certified for both Civil and Marine applications.
The HRTO has been designed to be sealed using standard Hawke tolerant blocks.
Hawke HRTO provide effectively sealing of cables and pipes through a circular aperture.
Hawke HRTO is suppied as an OPEN frame, so that it can be installed after laying the cables or pipes.
Hawke Round Transit (HRST)
Certified for Marine applications.
Hawke HRST is a round sealing solution for a single/pipe passing through a wall or bulkhead/deck.
Each size of HRST frame can seal a large range of diameters without any onsite modifications.
To seal services from 4mm to 170mm of external diameter (standard version).
Hawke Duct Seal is a sealing system for cables passing through ducts or pipes,
which ensures cabling is protected from
water, smoke, corrosive chemicals, rodents and debris.
Tried and tested in the field, Duct Seal is suitable for a wide range of cable including fibre optics, electrical wire, twisted pair or coax..
Its typical applications range from telecommunications to power distribution.
Hawke Compresion System
The Hawke compression system has 2 elements. The End Packer and
the Compression Plate.
Unique steel insert pins on both sides of the Hawke Transit Compression System ensure that the correct level of compression is applied to each installation,
without the need for special knowledge or decision on the part of the installer.